JavaScript seems to be disabled in your browser.

You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.


MicroSquirt V3 with Idle Stepper Control built in to Engine ECU

Price shown includes VAT at 20% ( £480 = £400 + vat )

This is a last unit of this MicroSquirt design we have in stock so selling at a reduced price to clear

Description
This version is loaded with MSxtra 3.4.1 firmware

No pulse width modulation (PWM) to limit injector current.
The fuel injector drives will max out at 5 amps each, enough to drive one low-impedance (or 4 high-impedance) injector per bank.
To get everything to fit without lots of heat sinking, MicroSquirt® uses the ST VND5N07 from STMicroelectronics to drive the injectors.
This is not a ‘peak and hold’ driver, but it does clamp the current at 5 amps, so it can be used with one low-impedance injector per bank, however the close time may be a tad higher (or you can use resistors).
For up to 4 high-impedance injectors per bank.
For example, for motorcycle use MicroSquirt® will be perfect!

No internal MAP sensor.
In order to shrink the ‘footprint’ of MicroSquirt® , the MAP sensor was left off the board.
An external MAP sensor, such as those from General Motors products, can be used instead.
See the MicroSquirt® hardware page for more information on MAP sensors.

****
Unlike most Microsquirt this version of MicroSquirt has been modifed by EFI Source so that it DOES have internal idle stepper motor control
This means you can use a standard 4 pin idle stepper control valve as used on many GM, Renault, Citroen and other vehicles.
****

Different connector and case.
The MicroSquirt® board uses the 35-pin AMPSEAL connector and a sealed case to make a fully sealed unit.
Amazingly, the board is the physical size of a business card – connector and all.
MicroSquirt’s® board size, including the 35-pin AMPSEAL connector, is very small – 2.4″ x 3.5″ (61mm x 89mm), just slightly bigger than a credit card.

Pre-loaded code: Unlike MegaSquirt® -II, MicroSquirt® comes with the embedded code already loaded onto its processor.
You can still upgrade to newer versions of the code as they are released, of course, but you won’t have to load the code initially to get MicroSquirt® working.

The bootloader is externally accessible, so there’s no need to open the case, even to load new code.
And the serial RS-232 signals come out of the AMPSEAL connector (instead of a DB-9 on the front, as with MicroSquirt® ).
The board is sealed in a weather proof enclosure.