Error Code Cleaner / Eraser for Renault Trucks all models from 2013 till now

Error Code Cleaner is standalone device. Using it is very easy and fast, just:

1. Turn ignition ON 
2. Connect Device to diagnostic connector of the vehicle.
3. Working/Done lamp starts blinking, wait until lights up permanently green. 
4. Switch ignition OFF and disconnect eraser, that's all!

All " Inactive " errors from supported systems are cleared!
It will not clear " Active " errors ( error codes where the fault cause is still present )

Renault Eraser supported systems:

• EMS - Engine ECU
• VMCU - Vehicle Master Control Unit
• ACM -Aftertreatment Control Module
• RET - Retarder
• TECU -Automatic Transmission
• BBM - Body Builder Module
• CCIOM - Central Module
• CCM - Air Condidioning 
• CIOM - Cabin Modele
• DACU - Driver Assistace Control Module
• DDM - Driver door Module
• DTCO - Tachograph
• EBS - Brake System
• FAS - 
• FCIOM - Front frame Module
• FLS - Radar
• HMIIOM - Multimedia Display
• IC - Instruments
• LECM - 
• LPOS - System Laneguard
• PDM -Passanger door Module
• RCIOM - Rear Controle Module
• SID - 
• TGW2 -Telematic Gateway
• VS - 
• WRC -
  

Supported Models (Series):

• Range T
• Range K
• Range C
• 
  

 This Device supports disabling Torque reduction / Speed reduction after Exhaust Aftertreatment System Failure !

The Error Code Cleaner checks connection with the vehicle. If there is no connection with vehicle it display the "Error" indicator. Thanks to this you can be sure that unwanted errors have been removed!

Error Code Cleaner is equipped with three indication modes:

1. Power - Light On when Cleaner has Power supply from diagnostic connector
2. Working/Done - this LED blinks when eraser is working and is permanently on when eraser finishes with success
3. Error - is permanently ON if there is no connection with vehicle or blinks when device is connected to unsupported vehicle