Error Code Cleaner / Eraser for Scania Trucks all models from 2004 till now

 Error Code Cleaner is standalone device. Using it is very easy and fast, just:

1. Turn ignition ON 
2. Connect Device to diagnostic connector of the vehicle.
3. Working/Done lamp starts blinking, wait until lights up permanently green. 
4. Switch ignition OFF and disconnect eraser, that's all!

All " Inactive " errors from supported systems are cleared!
It will not clear " Active " errors ( error codes where the fault cause is still present )

Scania Eraser supported systems:

• Engine (S6, S7, MD1)
• Brakes - EBS
• Coordinator
• Tachograph
• Automatic Gearbox
• Retarder
• APS
• AdBlue

Supported Models (Series):

• R Series Euro 3 /4 / 5 / 6 Including Next Generation
• P Series Euro 3 /4 / 5 / 6 Including Next Generation
• T Series Euro 3 /4 / 5 / 6 Including Next Generation
• G Series Euro 3 /4 / 5 / 6 Including Next Generation
• K Series Euro 3 /4 / 5 / 6 Including Next Generation
• S Series
• All Scania models from 2004 till now are supported !

 This Device supports disabling Torque reduction / Speed reduction after Exhaust Aftertreatment System Failure !

The Error Code Cleaner checks connection with the vehicle. If there is no connection with vehicle it display the "Error" indicator. Thanks to this you can be sure that unwanted errors have been removed!

Error Code Cleaner is equipped with three indication modes:

1. Power - Light On when Cleaner has Power supply from diagnostic connector
2. Working/Done - this LED blinks when eraser is working and is permanently on when eraser finishes with success
3. Error - is permanently ON if there is no connection with vehicle or blinks when device is connected to unsupported vehicle