We source these injectors from TRE in California.
They specialise in building and modifying injectors in their USA workshops.

All injectors supplied by them are flow tested on their ANSU flow rig before dispatch allowing us to sell the injectors in flow matched sets


These 630cc injectors are an ideal replacement to the now unobtainable Siemens Deka 630cc

Select quantity of injectors required to receive discounts for higher quantities

Specifications
Typical Flow Rate in LB per hour: 60 LBS/HR @ 45 PSI
Typical Flow Rate in CC per minute: 630 CC/min @ 45 PSI
Actual flow rate of your injectors may vary, but will be matched together
Resistance: 10 ohms (High Impedance, High Resistance)
Voltage: 8-15 Volts, nominal 13.5 Volts
Amperage: 1.0 Amps
Pressure: Min 30 PSIG / Max 100 PSIG
O-Rings Included: Yes, on the injectors
Injector Body Design: Metal and composite plastic
Fuel Delivery: Upgraded single fuel delivery nozzle for superior fuel atomization
Electrical connector type: EV1 (Minitimer, Jetronic)
Overall Length: 2 7/8 inches, 74 mm
O-ring to O-ring Length: 2 1/2 inches, 63 mm
Diameter: 16 mm
Orings: Top and bottom, 14.5 mm



Nominal flow of these injectors is 630cc but actual flow may vary during flow tests

Currently we have the following measured flow rates in stock

606 x 6
618 x 18
624 x 9
630 x 16
636 x 7
642 x 3

We will supply injectors in flow measured sets based on stock levels at the time but cannot normally guarantee supply of a specific flow from that list.